Honeywell HPS5 Power Supply Board

The Honeywell HPS5 power supply/battery charger can covert low voltage AC input into an output of 6 VDC, 12 VDC or 24 VDC @ 4.0 amps of continual supply current. This can be accomplished by adjusting the dip switches on the circuit board. If you have a lot of devices and go over the main board's power limits then this can be used. This will definitely give you more power than the our Ademco 12612.

AN OPEN-FRAME TRANSFORMER MUST BE USED FOR THIS

Specifications

• DIP Switch selectable for 6 VDC, 12 VDC or 24 VDC
output.
• 4.0 amps of continuous supply current*.
• Output is filtered and electronically regulated.
• Built-in charger for sealed lead acid or gel type batteries.
• Maximum charge current of 400 mA.
If a battery charger is used, subtract max charge current of
400 mA from total to determine allowable load.
• Automatically switches to stand-by battery upon AC fail.
• Battery protected from short circuits.
• Thermal and short circuit protection with auto reset.
• LED indicators for AC input and DC output.
• Compact design (board dimension 3.5"L x 2.75"W x
1.75"H).
• Battery leads and foam mounting tape included.