The Honeywell Vista 21ip is a upper level system that can do eight hardwire zones out of the box, with the capability to do up to 48 zones total (wired or wireless) with the use of hardwire expansion and wireless expansion modules. Has two built in low current trigger outputs with expansion capability of up to 16 total. Features two system partitions, plus a common partition area, supports two wire (up to 16) and four wire type smokes, features up to 48 user codes, and a time stamped 100 event log viewable on the 6160 series model keypads. The 6160, 6160RF, or 6160V alpha programmable keypads are required for initial setup. You may use any of the other Honeywell keypads that are listed on our site for secondary keypads, but a 6160 series keypad is a must to program these panels. It makes go through programming mode a breeze because of the alpha read out.
The Honeywell Vista 21ip is in essence a Vista 20P with an on-board IP communicator built-in from the manufacturer (GSM Communicator not included). If you'd like to add a GSM cellular communicator to make this a dual-path communicating system then you will want to purchase the VISTA-GSM snap-in module. You can only use the IP/GSM modules for central station monitoring service.
This Kit Includes:
1 - Vista 21ip Control
1 - 1640 Transformer
1 - Metal enclosure
Vista 21ip User Guide
Vista 21ip Programming Guide
The 6160, 6160RF, or 6160V alpha programmable keypads are required for initial setup. You may use any of the other Honeywell keypads that are listed on our site for secondary keypads, but a 6160 series keypad is a must to program these panels. It makes going through programming mode a breeze, because of the alpha read out.
